IC Microchip PIC18F2525 ( Rp. 200.000, -)

40-Pin Enhanced Flash Microcontrollers with 10-Bit A/ D and nanoWatt Technology. ---------------- Power Managed Modes: • Run: CPU on, peripherals on • Idle: CPU off, peripherals on • Sleep: CPU off, peripherals off • Idle mode currents down to 2.5 ¼ A typical • Sleep mode current down to 100 nA typical • Timer1 Oscillator: 1.8 ¼ A, 32 kHz, 2V • Watchdog Timer: 1.4 ¼ A, 2V typical • Two-Speed Oscillator Start-up Flexible Oscillator Structure: • Four Crystal modes, up to 40 MHz • 4x Phase Lock Loop ( PLL) – available for crystal and internal oscillators) • Two External RC modes, up to 4 MHz • Two External Clock modes, up to 40 MHz • Internal oscillator block: - 8 user selectable frequencies, from 31 kHz to 8 MHz - Provides a complete range of clock speeds from 31 kHz to 32 MHz when used with PLL - User tunable to compensate for frequency drift • Secondary oscillator using Timer1 @ 32 kHz • Fail-Safe Clock Monitor - Allows for safe shutdown if peripheral clock stops Peripheral Highlights: • High-current sink/ source 25 mA/ 25 mA • Three programmable external interrupts • Four input change interrupts • Up to 2 Capture/ Compare/ PWM ( CCP) modules, one with Auto-Shutdown ( 28-pin devices) • Enhanced Capture/ Compare/ PWM ( ECCP) module ( 40/ 44-pin devices only) : - One, two or four PWM outputs - Selectable polarity - Programmable dead time - Auto-Shutdown and Auto-Restart Peripheral Highlights ( Continued) : • Master Synchronous Serial Port ( MSSP) module supporting 3-wire SPI™ ( all 4 modes) and I2C™ Master and Slave modes • Enhanced Addressable USART module: - Supports RS-485, RS-232 and LIN 1.2 - RS-232 operation using internal oscillator block ( no external crystal required) - Auto-Wake-up on Start bit - Auto-Baud Detect • 10-bit, up to 13-channel Analog-to-Digital Converter module ( A/ D) : - Auto-acquisition capability - Conversion available during Sleep • Dual analog comparators with input multiplexing • Programmable 16-level High/ Low-Voltage Detection ( HLVD) module: - Supports interrupt on High/ Low-Voltage Detection Special Microcontroller Features: • C compiler optimized architecture: - Optional extended instruction set designed to optimize re-entrant code • 100, 000 erase/ write cycle Enhanced Flash program memory typical • 1, 000, 000 erase/ write cycle Data EEPROM memory typical • Flash/ Data EEPROM Retention: 100 years typical • Self-programmable under software control • Priority levels for interrupts • 8 x 8 Single Cycle Hardware Multiplier • Extended Watchdog Timer ( WDT) : - Programmable period from 4 ms to 131s • Single-supply 5V In-Circuit Serial Programming™ ( ICSP™ ) via two pins • In-Circuit Debug ( ICD) via two pins • Wide operating voltage range: 2.0V to 5.5V • Programmable Brown-out Reset ( BOR) with software enable option